Enamel for Copper, Silver and Gold. This enamel is "medium fusing" and should be fired at 1346 to 1418 degrees F. for approximately 2 to 4 minutes. All Enamel is new stock and lead bearing.
The enamel used for making the pictured samples has been "washed." All enamel is sold unwashed. Washing is not required for use, but recommended.
Enamel for Copper, Silver. This enamel is "soft fusing" and should be fired at 1292 to 1346 degrees F. for approximately 2 to 4 minutes. All Enamel is new stock and lead bearing.
The enamel used for making the pictured samples has been "washed." All enamel is sold unwashed. Washing is not required for use, but recommended.
Enamel for Copper, Silver and Gold. This enamel is "medium fusing" and should be fired at 1346 to 1418 degrees F. for approximately 2 to 4 minutes. All Enamel is new stock and lead bearing.
The enamel used for making the pictured samples has been "washed." All enamel is sold unwashed. Washing is not required for use, but recommended.
Enamel for Copper, Silver and Gold. This enamel is "medium fusing" and should be fired at 1346 to 1418 degrees F. for approximately 2 to 4 minutes. All Enamel is new stock and lead bearing.
The enamel used for making the pictured samples has been "washed." All enamel is sold unwashed. Washing is not required for use, but recommended.
Enamel for Copper, Silver and Gold. This enamel is "medium fusing" and should be fired at 1346 to 1418 degrees F. for approximately 2 to 4 minutes. All Enamel is new stock and lead bearing.
The enamel used for making the pictured samples has been "washed." All enamel is sold unwashed. Washing is not required for use, but recommended.
Enamel for Copper, Silver and Gold. This enamel is "Hard fusing" and should be fired at 1418 to 1508 degrees F. for approximately 2 to 4 minutes. All Enamel is new stock and lead bearing.
The enamel used for making the pictured samples has been "washed." All enamel is sold unwashed. Washing is not required for use, but recommended.
Enamel for Copper, Silver and Gold. This enamel is "soft fusing" and should be fired at 1292 to 1346 degrees F. for approximately 2 to 4 minutes. All Enamel is new stock and lead bearing.
The enamel used for making the pictured samples has been "washed." All enamel is sold unwashed. Washing is not required for use, but recommended.
The Schauer transparent range, ground to 60 mesh and unusually deep in the reds — 8, 9, 10, 111 Garnet, 114, 115, 116, 1216, 1729 Wine Red and 5005 all sit in the ruby family — with golden yellows, ambers, olives, browns and greens alongside. New stock, lead bearing, sold in 1 ounce jars with 8 and 16 ounce sizes. A transparent reads differently over foil, over flux and directly on copper, so a test firing on your own metal is worth the ounce. Firing temperatures are on the Schauer data sheet linked below. Opaques from the same maker are in Schauer Opaques.
WARNING: These products can expose you to chemicals including lead, cadmium, cobalt, lithium carbonate, silica, crystalline (airborne particles of respirable size), titanium dioxide, which are known to the State of California to cause cancer, birth defects or other reproductive harm (www.P65warnings.ca.gov).
Schauer Transparent Enamels
For firing temperatures and metal compatibility please see the Schauer Data Sheet at
